Xerox WorkCentre 7132

January 2007
2-63
WorkCentre 7132
005-127, 005-128
Status-indicator-raps
Revision
005-127 CVT Out Sensor Off Jam
BSD-ON:5.4
Out Sensor does not turn Off in specified time fro Reg.Sensor Off.
Procedure
If the problem occurs frequently, check the following:
1. There is any area in document path that interferes with document feed.
2. Any foreign substance is attached Roll surface.
3. Roll surface has worn abnormally.
4. Reg.Motor rotates normally.
5. Platen Motor rotates normally.
6. Check the connectors and wires for damage.
If all above are OK, replace Out Sensor (PL 16.9). If the problem persists, replace the DADF
PWB (PL 16.3).
005-128 CVT Simplex Exit 1 Sensor On Jam
BSD-ON:5.4
Exit 1 Sensor does not turn On in specified time from Out Sensor On in Simplex Mode.
Procedure
If the problem occurs frequently, check the following:
1.There is any area in document path that interferes with document feed.
2. Any foreign substance is attached to Roll surface.
3. Roll surface has worn abnormally.
4. Simp/Dup Gate is in normal position (Simp/Dup Gate Solenoid operation included.)
5. Platen Motor rotates normally.
6. Exit Motor rotates normally.
7. Check the connectors and wires for damage.
If all above are OK, replace Simplex Exit 1 Sensor (PL 16.7). If the problem continues, replace
the Exit 1 Sensor (PL 16.7). If the problem persists, replace the DADF PWB (PL 16.3).