January 2007
2-877
WorkCentre 7132
OF 1
Status-indicator-raps
Revision
OF 1 Paper Size Mismatch In Width RAP
The width of the paper size is incorrect.
Initial Actions
• Power OFF/ON
• Reload the tray.
Procedure
Check for foreign substances, distortion and paper powder in the paper transport path. No
distortion, foreign substances, or paper powder are found in the paper transport path.
YN
Clear away the foreign substances and paper powder. Correct the distortion.
Feed paper from another tray. The problem occurs when paper is fed from another tray.
YN
Check the guide. The guide is set correctly.
YN
Set the guide correctly.
Check the operation of the Guide Actuator. The Guide Actuator works.
YN
Set the guide correctly.
Check the installation of the relevant Paper Size Switch. The relevant Paper Size
Switch is installed correctly.
YN
Install the relevant Paper Size Switch correctly.
Go to the OF 2 (SIZE SWITCH ASSY RAP).
Replace the MCU PWB (PL 11.1).
To Next Page
Loading...
Need help?
General
