January 2007
3-12
WorkCentre 7132
IQ13
Reversion 4.0
Image Quality
IQ13 Unfused Copy/Toner Offset RAP
Initial Actions
• Replace the paper in use with fresh, dry paper of the correct specification.
• Check the post-Fuser transport areas for dirt.
• Ensure that the media being used matches the settings on the UI screen or print driver.
Using the next heavier setting may resolve the problem.
• If the Key Operator/Administrator has configured certain trays for a specific type of media,
ensure that the specified media is actually loaded in those trays.
Procedure
Check the following:
• Check the Fuser (PL 7.1) for damage, toner offsetting, paper wrap, or incorrect installa-
tion. Clean or replace as required.
After resolving the problem, make 10 blank copies (letter size, Black mode) to cleaner residual
toner from the Fuser Heat Roll and Fuser Pressure Belt. If the problem persists, replace the
Fuser (PL 7.1).
To Next Page
Loading...
