January 2007
2-69
WorkCentre 7132
005-135, 005-136
Status-indicator-raps
Revision
Check the wire between J765 and J755 for an open circuit or a short circuit (BSD 5.5 Flag
2).
The wire between J765 and J755 is conducting without an open circuit or a short
circuit.
YN
Repair the open circuit or short circuit.
Measure the voltage between the DADF PWB P755-1 (+) and GND (-), and between
P755-6 (+) and GND (-) (BSD 5.5 Flag 2).
The voltage is approx. +24VDC.
YN
Replace the DADF PWB (PL 16.3).
Replace the DADF Registration Motor (PL 16.9) If the problem persists, replace the
DADF PWB (PL 16.3).
Execute Component Control [005-072]. The Exit Nip Release Solenoid can be heard.
YN
Check the connections of P/J766 and P/J756. P/J766 and P/J756 are connected cor-
rectly.
YN
Connect P/J766 and P/J756.
Check the wire between P756 and J766 for an open circuit or a short circuit (BSD 5.6 Flag
2).
The wire between P756 and J766 is conducting without an open circuit or a
short circuit.
YN
Repair the open circuit or short circuit.
Replace the Exit Nip Release Solenoid (PL 16.4) If the problem persists, replace the
DADF PWB (PL 16.3).
Replace the DADF PWB (PL 16.3).
005-136 CVT Side2 Registration On Jam RAP
BSD-ON:5.4/5.5/5.6
After the DADF Pre Registration Sensor turned On at Invert, the DADF Registration Sensor did
not turn On within the specified time.
Initial Actions
• Power Off than On
Procedure
Execute Component Control [005-110]. Actuate the DADF Registration Sensor with paper.
The display changes.
YN
Check the connections of P/J782 and P/J761 P/J782 and P/J761 are connected cor-
rectly.
YN
Connect P/J782 and P/J761.
Check the wire between J782 and J761 for an open circuit or a short circuit (BSD 5.5 Flag
1/Flag 2).
The wire between J782 and J761 is conducting without an open circuit or
a short circuit.
YN
Repair the open circuit or short circuit.
Measure the voltage between the DADF PWB P761-15 (+) and GND (-) (BSD 5.5 Flag
2).
The voltage is approx. +5VDC.
YN
Replace the DADF PWB (PL 16.3).
Measure the voltage between the DADF PWB P761-14 (+) and GND (-) (BSD 5.5 Flag 1).
Actuate the DADF Registration Sensor with paper. The voltage changes.
YN
Replace the DADF Registration Sensor (PL 16.7).
Replace the DADF PWB (PL 16.3).
Execute Component Control [005-001]. The DADF Feed Motor starts up.
YN
Check the connections of P/J764 and P/J754. P/J765 and P/J754 are connected cor-
rectly.
YN
Connect P/J765 and P/J754.
Check the wire between J765 andJ754 for an open circuit or a short circuit (BSD 5.5 Flag
1).
The wire between J765 and J754 is conducting without an open circuit or a short
circuit.
YN
Repair the open circuit or short circuit.
A B
A B
To Next Page
Loading...
Need help?
General
