January 2007
4-217
WorkCentre 7132
REP 22.8.2
Repairs/Adjustments
Reversion 4.0
REP 22.8.2 Stacker Shaft Assembly
Parts List on PL 22.8
Removal
WARNING
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
CAUTION
Before turning OFF the power switch, note the following to prevent loss of customer data.
[with the FAX function]
Check that the “Job in Memory” lamp is off. Press the “Job Status” button and check that no job
is in progress.
[with the Printer function]
Check that “Ready to print/send” is displayed on the Control Panel.
1. Remove the A-Finisher from the machine.
2. Remove the Rear Cover. (PL 22.1)
3. Turn over the A-Finisher.
4. Remove the Tray Cover. (PL 22.2)
5. Remove the rear Bracket. (Figure 1)
(1)Remove Screw.
(2)Remove Bracket.
Figure 1 Removing the Bracket (j0fa42252)
6. Remove the front Bracket. (Figure 2)
(1)Remove Screw.
(2)Remove Bracket.
Figure 2 Removing the Bracket (j0fa42253)
7. Remove the Top Tray. (Figure 3)
(1)Raise A-Finisher slightly in the direction of the arrow.
(2)Remove Top Tray.
Figure 3 Removing the Top Tray (j0fa42254)
8. Disconnect Connector. (Figure 4)
(1)Release Clamps (5) and remove the wire.
(2)Release Wire from Hook.
(3)Disconnect Connector.
To Next Page
Loading...
Need help?
General
