Xerox WorkCentre 7132

January 2007
2-851
WorkCentre 7132
124-374, 124-380
Status-indicator-raps
Revision
124-374 IOT IM Device Driver Software RAP
BSD-ON:16.1
Due to an error in the software of the IOT IM Device Driver, subsequent processes cannot be
performed.
Procedure
Reload Software (ADJ 9.3.1).
If the problem persists reinstall or replace the DDR DIMM (PL 11.2).
If the problem persists replace the ESS PWB (PL 11.2).
124-380 CRUM Market (2)
There is a general CRUM control failure.
Procedure
Check the electrical connections on the ESS PWB and MCU PWB. The connectors are
securely connected.
YN
Connect the connectors.
Turn on the power again. The problem persists.
YN
Return to Service Call Procedures.
Replace the ESS PWB (PL 11.2)
If the problem persists replace the MCU PWB (PL 11.1).