January 2007
2-801
WorkCentre 7132
121-340, 121-350
Status-indicator-raps
Revision
121-340 EP Accessory Mismatch RAP
The combination of accessories that are installed does not match the specifications.
Initial Actions
Power Off/On
Procedure
Check the electrical connections on the HDD (PL 11.2)
If the problem persists reload Software (ADJ 9.3.1).
If the problem persists perform Hard Disk Diagnostic Program.
If the problem persists reinstall or replace the EPSV-IF board (PL 11.2).
If the problem persists pull out and insert or replace the DDR DIMM (PL 11.2).
If the problem persists replace the ESS PWB (PL 11.2).
121-350 EPSV Logic HDD RAP
A fatal error was detected.
Initial Actions
Power Off/On
Procedure
Check the electrical connections on the HDD (PL 11.2)
If the problem persists reload Software (ADJ 9.3.1).
If the problem persists perform Hard Disk Diagnostic Program.
If the problem persists reinstall or replace the EPSV-IF board (PL 11.2).
If the problem persists pull out and insert or replace the DDR DIMM (PL 11.2).
If the problem persists replace the ESS PWB (PL 11.2).
To Next Page
Loading...
