January 2007
6-164
WorkCentre 7132
Controller & Fax NVM List
Reversion 4.0
General procedures information
Chain 850-xxx EP-SV
830-109 Reply MDN Request Reply MDN Mail 0~1 1 Read/Write 0: Never reply, 1: Always reply
830-116 Ifax Sending Path Specification IFAX Neto Config Route 1~2 1 Read/Write
1: By MTA, 2: By P2P, 3: By user specification (not immediate
830-118 P2P Ifax Retry Attempts IFAX Neto Config Retry Coun 0~5 1 Read/Write 0: Do not retry, 1-5: Retry attempts
830-119 P2P Ifax Retry Interval (Unit: Minutes) IFAX Neto Config Retry Interval 0~60 1 Read/Write 0: Immediate retry, 1-60: Interval (Minutes)
830-120 Print Mode when Receiving IFAX IFAX Print Mode 0, 1 0: Auto distrib-
ute
Read/Write 0: Auto distribute, 1: Print as IFAX data
Table 12 iFAX Service
Chain-Link NVM Name PSW Display Setup Range Initial Value Read/Write Description
Table 13 EP-SV
Chain-Link NVM Name Setup Range Initial Value Read/Write Description
850-001 EP-SV, EP Accessory Connection 0~1 0: OFF Read/Write 0: OFF, 1: ON
850-002 Telephone line connection 0~1 0: OFF Read/Write 0: OFF, 1: ON
850-003 EP Data Send Type (This data is the
same as that of EP-DX)
0~2 0: Send to
EP-SV
Read/Write 0: Send to EP-SV, 1: Send to EP-DX, 2: Send to both
850-004 Enable Display at bundling (This
data is the same as that of EP-DX)
0~1 0: Prohibit Read/Write 0: Prohibit, 1: Implement
850-007 Types of accessories 0~12 - Read/Write 0: Off, 1: CopyLyzer (Addition), 2: CopyLyzer (Subtraction), 3: Dispenser, 4:
Coin Kit5, 5: Combination of CopyLyzer and Copy Dispenser, 6: Combination
of CopyLyzer and Coin Kit 5, 7: Combination of Dispenser and Coin Kit 5, 10:
IC Card Gate
850-009 Print Control Function 0~1 0: Do not
control oper
-
ation
Read/Write 0: Do not control operation, 1: Control operation
850-010 Interrupt operation when connected
to subtraction type
0~1 1: Interrupt
Off
Read/Write 0: Interrupt On, 1: Interrupt Off
850-011 CRU Replacement Notification
Enable/Disable
0~1 0: Prohibit Read/Write 0: Prohibit, 1: Permit
850-012 CRU Warning Notification Enable/
Disable
0~1 0: Prohibit Read/Write 0: Prohibit, 1: Permit
850-015 Scan/Fax/I-Fax Control Feature 0~1 0: Do not
control oper
-
ation
Read/Write 0: Do not control operation, 1: Control operation
850-016 Operation for Disable Receive when
connected to subtraction type
0~1 0: Cancel
Job (Cancel)
Read/Write 0: Cancel Job (Cancel), 1: Pause Job
850-017 Use Card Number in Print Control 0~1 1: Use Card
No.
Read/Write 0: Do not use Card No., 1: Use Card No.
850-018 Paper feeding mode for 2 Sided
Printing when connected to the con
-
ventional subtraction type accessory
0~1 1: One sheet
mode
Read/Write 0: Clear one sheet mode and speed up, 1: One sheet mode