January 2007
4-241
WorkCentre 7132
ADJ 9.1.1
Repairs/Adjustments
Reversion 4.0
Figure 2 Creating a Test Pattern Original
4. Place the Test Pattern Original face down on the platen glass with the short edge against
the left registration edge.
5. From the UI Copying screen, select Black, 1-2 sided, 100%, Tray 1 and press the Start
Button.
6. After the first pass of the lens, place a small piece of paper under the Test Pattern Origi-
nal, with the words “Side 2” written on it.
7. Press the Start button.
8. Remove the print from the center exit tray and position it as indicated in the following
note.
NOTE: Duplex copies will be delivered to the center output tray face down. To view the
duplex prints for registration analysis, remove the prints from the tray and flip it left to
right. The words “Side 2” should be visible.
NOTE: The Trail Edge of the image is being measured to the Trail Edge of the paper and
the entire image is shifted by any adjustments.
9. Fold the copy in half in both directions.
10. The printed lines should align with the folds.
11. If not, measure and record the direction and distance the image need to be moved to align
them with the folds. (Figure 3)
Figure 3 Measuring the distance to move the image
NOTE: 9 bits = 1mm
12. Enter NVM Read/Write and enter 742-046, then select Confirm/Change.
13. Enter the new NVM value into the Current Value, and press the Start Button.
14. Repeat steps 4 through 11 until the correct Lead Edge measurement is achieved.
Side Edge Registration
Purpose
To center the image from the side edges of the paper.
Optionally, the SE registration can be set for each tray individually; use the Tray 1 through MSI
buttons and repeat the check or adjustment for each tray.
Adjustment
NOTE: Exit and re-enter the Diagnostic Mode in order for the Side Edge Registration
changes to take effect.
1. Enter UI Diagnostic Mode.
2. Enter Print Test Pattern, and print Test Pattern #58.
To Next Page
Loading...
Need help?
General
