Xerox WorkCentre 7132 Service Documentation

January 2007
6-95
WorkCentre 7132
Controller & Fax NVM List
General procedures information
Reversion 4.0
700-368 lpd: Memory Spool 512~1024 1MB Read/Write Memory spooling: [512KB~32MB](256KB increments) Unit: Kbyte
700-390 Memory size for mail print (E-mail To Print) 64~1024 256KB
(256)
Read/Write 64K~1M Byte Unit: Kbyte
700-396 Auditron Color Mode for Copy (Color Mode
for unauthenticated user)
0~2 0: Prohibit Read/Write 0: ProhiBit, 1: BW, 2: BW & Low Price Color
700-397 Default Paper Size for Reports 5~44 5: A4 (FX/
AP
default),
44: Letter
(XC
default)
Read/Write 5: A4, 44: Letter
700-398 CE Auditron Mode: (Print User Restriction
Setup Menu Display)
0~1 1: Display Read/Write 0: No display 1: Display
700-399 Millimeter/Inch Settings 1~3 1: Millime-
ter (FX/AP
default), 3:
Inch (XC
default)
Read/Write 1: Millimeter, 3: Inch
700-401 Paper Size Group (NVM) 1~5 The value
specified in
Paper Size
Group
(Factory
Settings
SEEPROM
)
Read/Write 1: Japan, 2: NA (North America), 3: EU, 4: AP, 5: SA (South America)
700-402 Paper Size Group (SEEPROM) 1~5 Sets every
destination
at the fac
-
tory
Read/Write 1: Japan, 2: NA (North America), 3: EU, 4: AP, 5: SA (South America)
700-410 Electronic Sort Print Area Size (RAM Disk) 33M with
standard
memory,
50M with
128M
expansion
memory,
and 66M
with 256M
expansion
memory
Read/Write This setting becomes valid only when extending the printer kit with HDD not
installed. Do not set other than the situation above. The setting range is from 0
to “current value + amount of free memory”. Setting increment is 1MB Units.
The current value can be checked from the System Settings List of the device,
while the amount of free memory can be checked from the Memory Settings
Menu.
CAUTION
If a value that is larger than the “current value + amount of free memory” is
entered, every Memory Settings (inclusive of Receiving Buffer of the Host IF,
Form Memory, etc.) will revert to their Factory Shipment Settings.
Please make sure that the total of the increased portion does not exceed the
amount of free memory if the Electronic Sort Copy Size is also changed.
The Electronic Sort function listed to the left stops when its value is set to “0”.
However, please do not set only this value to “0”. Also set the Electronic Sort
Copy Area to “0” when setting this value to “0”.
Table 1 Common
Chain-Link NVM Name
Setup
Range
Initial
Value Read/Write Description

Xerox WorkCentre 7132 Specifications

General

Brand	Xerox
Model	WorkCentre 7132
Category	All in One Printer
Language	English