EasyManuals Logo

Renesas RX Series User Manual

Renesas RX Series
1823 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1598 background imageLoading...
Page #1598 background image
R01UH0823EJ0100 Rev.1.00 Page 1598 of 1823
Jul 31, 2019
RX23W Group 44. 12-Bit A/D Converter (S12ADE)
The following is an example of a rescanning operation in which a group B trigger is input during A/D conversion on
group A. In this example, channels 1 to 3 are selected for group A and channel 0 is selected for group B when operation
on group A is given priority (ADGSPCR.GBRSCN = 1, ADGSPCR.GBRP = 0).
(1) When input of a trigger for group A sets the ADCSR.ADST bit to 1 (A/D conversion start), conversion for the ANn
channels selected in the ADANSA0 and ADANSA1 registers, starting from the channel with the smallest number n.
(2) On completion of A/D conversion on a single channel, the result is stored in the corresponding A/D data register
(ADDRy).
(3) If a group B trigger is input during A/D conversion on group A, A/D conversion on group B can be performed after
the A/D conversion on group A is completed. (However, if group A triggers are input continuously, the scan
operation on group B is canceled by group A and is not performed.)
(4) On completion of the A/D conversion on the group A, an S12ADI0 interrupt request is generated if the setting of the
ADCSR.ADIE bit is 1 (S12ADI0 interrupt upon scanning completion enabled).
(5) On completion of the A/D conversion on the group A, activation of group B for rescanning sets the ADCSR.ADST
bit to 1 automatically.
After that, conversion for the ANn channels of group B selected in the ADANSB0 and ADANSB1 registers,
starting from the channel with the smallest number n.
(6) On completion of A/D conversion on a single channel, the result is stored in the corresponding A/D data register
(ADDRy).
(7) On completion of the rescanning operation on the group B, a GBADI interrupt request is generated if the setting of
the ADCSR.GBADIE bit is 1 (GBADI interrupt upon scanning completion enabled).
(8) The ADST bit retains the value 1 (A/D conversion start) during A/D conversion and is automatically cleared on
completion of conversion, after which the A/D converter enters a wait state.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Renesas RX Series and is the answer not in the manual?

Renesas RX Series Specifications

General IconGeneral
CoreRXv1, RXv2, RXv3
Flash MemoryUp to 8 MB
RAMUp to 1 MB
Operating Voltage1.62V to 5.5V
Operating Temperature-40°C to +85°C or +105°C
PackageBGA, LQFP
ADC Resolution12-bit
DAC Resolution12-bit
Communication InterfacesSCI, SPI, I2C, USB, Ethernet, CAN
Architecture32-bit
Security FeaturesMemory Protection Unit (MPU)

Related product manuals