3 Short-Range Comms & IoT Mode
3.8 SEM Measurement
Mode Preset is pressed while Global EMC Std is ON, Global EMC Std is preset to the
preset EMC Std of the current Mode.
This function resets to OFF when "Restore Defaults" on page 1719 is pressed, or
when System, Restore Defaults, All Modes is pressed.
Remote Command
:INSTrument:COUPle:EMC:STANdard ALL | NONE
:INSTrument:COUPle:EMC:STANdard?
Example
:INST:COUP:EMC:STAN ALL
:INST:COUP:EMC:STAN?
Dependencies Only available if Option EMC is installed
Preset Set to OFF on Global Settings, Restore Defaults and System, Restore Defaults, All Modes
Range
ALL | NONE
Restore Defaults
Resets all functions in the Global settings menu to OFF. Pressing System, Restore
Defaults, All Modes has the same effect.
Remote Command
:INSTrument:COUPle:DEFault
Example
:INST:COUP:DEF
Backwards Compatibility
SCPI
:GLOBal:DEFault
3.8.19 Sweep
Accesses controls to configure and control the acquisition of data, and the X-axis
parameters of the instrument.
Depending on the selected mode and measurement, these controls might include:
Sweep Time, Continuous/Single, Pause/Resume, X Scale and Number of Points.
3.8.19.1 Sweep/Control
Accesses controls that let you operate the sweep and control functions of the
instrument, such as Sweep Time and Continuous/Single.
Sweep/Measure
Lets you toggle between Continuous and Single sweep or measurement operation.
The single/continuous state is Meas Global, so the setting affects all measurements.
The front-panel key Single/Cont performs exactly the same function
1186 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
