3 Short-Range Comms & IoT Mode
3.4 HRP UWB Demodulation Measurement
Shows the measurement numeric results. The available tabular data changes
depending on the modulation format chosen.
3.4.2.6 Decoded Bits
Window #6
Shows the decoded bits.
3.4.2.7 Frame Info
Window #7
Shows the detail frame information results.
Specifically, for ERDEV-HPRF, and when “Frame Length” in Configure Frame panel
is larger than 1023, Frame Length in this result window is displayed as two values;
for example, A(B):
A Value based on PHR bits L0-L9
B Value based on PHR bits L0-L9 and A0/A1
Note this result could be inaccurate if the “Frame Length” in Configure Frame panel does not
match the signal, and could thus lead to incorrect interpretation of A0/A1
3.4.2.8 Impulse Response
Window #8
Shows baseband impulse response and mask limit lines.
3.4.2.9 Error Vector Time
Window #9
Shows error vector on each chip.
Note: the x-axis values are in units of Chips. There are X points per Chips (X =
points/chips, and X is equal to nOverSampled), so the decision points of the x-axis
values are at 0, 1 * X, 2 * X,….
3.4.2.10 MMS Packet Results
Window #10
Shows MMS packet results.
438 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
