Keysight x-series Instruction Manual

3 Short-Range Comms & IoT Mode
3.4 HRP UWB Demodulation Measurement
If there is no valid peak lower than the current marker position, a “No peak found”
message is generated, and the marker is not moved.
If the selected marker was Off, then it is turned on as a Normal marker and a peak
search is performed.
Remote Command
:CALCulate:HUWB:MARKer[1]|2|…|12:MAXimum:NEXT
Example
:CALC:HUWB:MARK2:MAX:NEXT
State Saved Not part of saved state
Next Pk Right
Moves the selected marker to the nearest peak right of the current marker that
meets all enabled peak criteria. If there is no valid peak to the right of the current
marker position, a “No peak found” message is generated, and the marker is not
moved.
If the selected marker was Off, then it is turned on as a Normal marker and a peak
search is performed.
Remote Command
:CALCulate:HUWB:MARKer[1]|2|…|12:MAXimum:RIGHt
Example
:CALC:HUWB:MARK2:MAX:RIGH
Notes Sending this command selects the subopcoded marker
State Saved Not part of saved state
Next Pk Left
Moves the selected marker to the nearest peak left of the current marker that meets
all enabled peak criteria. If there is no valid peak to the left of the current marker
position, a “No peak found” message is generated, and the marker is not moved.
If the selected marker was Off, then it is turned on as a Normal marker and a peak
search is performed.
Remote Command
:CALCulate:HUWB:MARKer[1]|2|…|12:MAXimum:LEFT
Example
:CALC:HUWB:MARK2:MAX:LEFT
State Saved Not part of saved state
Minimum Peak
Moves the specified marker to the minimum y-axis value on the current trace.
Minimum (negative) peak searches do not have to meet the peak search criteria. The
search is simply for the lowest y-axis value.
If the selected marker is Off, it is turned on before the minimum search is performed.
494 Short Range Comms & IoT Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)