9 Programming the Instrument
9.4 Status Register System & STATus Subsystem
The variable <integer> is the sum of the decimal values of the bits that you want to
enable.
Remote
Command
:STATus:QUEStionable:CALibration:EXTended:FAILure:ENABle <integer>
:STATus:QUEStionable:CALibration:EXTended:FAILure:ENABle?
Example
:STAT:QUES:CAL:EXT:FAIL:ENAB 1
Can be used to query if an EMI conducted alignment failed
Preset 32767
Min 0
Max 32767
Status Bits/OPC
dependencies
Sequential command
Questionable Calibration Extended Failure Event Query
Returns the decimal value of the sum of the bits in the Questionable Calibration
Extended Failure Event register.
NOTE
The register requires that the associated PTRansition or NTRansition filters be
set before a condition register bit can set a bit in the event register. The data in
this register is latched until it is queried. Once queried, the register is cleared.
Remote
Command
:STATus:QUEStionable:CALibration:EXTended:FAILure[:EVENt]?
Example
:STAT:QUES:CAL:EXT:FAIL?
Preset 0
Status Bits/OPC
dependencies
Sequential command
Questionable Calibration Extended Failure Negative Transition
Determines which bits in the "Questionable Calibration Extended Failure Condition"
on page 2492 register will set the corresponding bit in the "Questionable Calibration
Extended Failure Event Query" on page 2493 register when the condition register bit
has a negative transition (1 to 0).
The variable <integer> is the sum of the decimal values of the bits that you want to
enable.
Remote
Command
:STATus:QUEStionable:CALibration:EXTended:FAILure:NTRansition <integer>
:STATus:QUEStionable:CALibration:EXTended:FAILure:NTRansition?
Example
:STAT:QUES:CAL:EXT:FAIL:NTR 1
2493 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
