Keysight x-series Instruction Manual

6 Input/Output
6.9 Calibration
6.9.1.5 Copy From Cal Group
Determines the Cal Group from which existing rows are copied when using the
"Copy" on page 2182Group feature.
Remote
Command
:SYSTem:CALibration:CGRoup:COPY:FROM <integer>
:SYSTem:CALibration:CGRoup:COPY:FROM?
Example
:SYST:CAL:CGR:COPY:FROM 2
:SYST:CAL:CGR:COPY:FROM?
Preset 1
Min 1
Max 100
6.9.1.6 Copy
Lets you copy the settings in the Cal Group specified by the Copy From Cal Group
parameter.
All the rows in the table are copied to the selected Cal Group. The columns Apply,
Last Cal and Applied are set to their default values.
The group level parameters are also copied, with the exception of Apply Cal Group
and Copy From Cal Group.
Remote Command
:SYSTem:CALibration:CGRoup:COPY
Example
:SYST:CAL:CGRoup:COPY
Dependencies Applied to the currently selected Cal Group
Couplings Disabled if Copy From Cal Group is the same as the currently selected Cal Group. If the disabled
control is selected, the advisory message “Unable to Copy from same Cal Group” is displayed, and the
same message is returned remotely as a Settings Conflict
If you attempt to copy from a Cal Group that is empty, the advisory message “Copy From Cal Group is
empty” is displayed, and the same message is returned remotely as a Settings Conflict
Short Range Comms & IoT Mode User's &Programmer's Reference 2182

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)