Keysight x-series Instruction Manual

3 Short-Range Comms & IoT Mode
3.2 Modulation Analysis Measurement
Restart
The Restart function restarts the current sweep, or measurement, or set of
averaged/held sweeps or measurements. If you are Paused, pressing Restart does a
Resume.
The front-panel key Restart performs this exact same function
The Restart function is accessed in several ways:
–
Pressing the Restart key
–
Sending the remote command INIT:IMMediate
–
Sending the remote command INIT:RESTart
Remote
Command
:INITiate[:IMMediate]
:INITiate:RESTart
Example
:INIT:IMM
:INIT:REST
Notes :INITiate:RESTart and :INITiate:IMMediate perform exactly the same function
Couplings Resets average/hold count k. For the first sweep overwrites all active (update=on) traces with new
current data. For application modes, it resets other parameters as required by the measurement
Status Bits/OPC
dependencies
This is an Overlapped command
The STATus:OPERation register bits 0 through 8 are cleared
The STATus:QUEStionable register bit 9 (INTegrity sum) is cleared
The SWEEPING bit is set
The MEASURING bit is set
Pause/Resume
Pauses a measurement after the current data acquisition is complete.
When Paused, the label on the control changes to Resume. Pressing Resume un-
pauses the measurement. When you are Paused, pressing Restart does a Resume.
Remote Command
:INITiate:PAUSe
:INITiate:RESume
Example
:INT:PAUS
:INT:RES
Dependencies Not displayed in Modes that do not support Pausing
Annotation Only on control
Short Range Comms & IoT Mode User's &Programmer's Reference 301

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)