To Next Page

To Previous Page

3 Short-Range Comms & IoT Mode

3.7 ACP Measurement

Preset For Swept SA Measurement (in SA Mode):

1|0|0|0|0|0

ON for Trace 1; OFF for 2–6

For all other measurements:

1|0|0

ON for Trace 1; OFF for 2 &3

State Saved Saved in instrument state

More Information

When a trace becomes inactive, any update from the :SENSe system (detectors)

immediately stops, without waiting for the end of the sweep. The trace data remains

unchanged, but stops updating. If the trace is blanked, this still does not affect the

data in the trace. Traces that are blanked (Display=OFF) do not display nor appear

on printouts, but their data stays intact, they may be queried, and markers may be

placed on them

In most cases, inactive traces are static and unchanging; however, there are cases

when an inactive trace will update, specifically:

–

if data is written to that trace from remote

–

if trace data is loaded from mass storage

–

if the trace is the target of a Copy or participant in an Exchange

–

if the trace is cleared using Clear Trace

Inactive traces that are also being displayed (traces in View) are displayed at half

intensity. Traces in View display across the entire X-Axis of the instrument. Their

horizontal placement does not change, even if X-Axis settings subsequently are

changed, although Y-Axis settings do affect the vertical placement of data.

When a trace becomes active (Update=ON), the trace is cleared, the average count is

reset, and a new sweep is initiated.

Note that putting a trace into Display=OFF and/or Update=OFF does not restart the

sweep and does not restart Averaging or Hold functions for any traces.

3.7.15.3 Math

Lets you turn on and configure Trace Math functions.

996 Short Range Comms & IoT Mode User's &Programmer's Reference

Keysight x-series Instruction Manual

Other manuals for Keysight x-series