Keysight x-series Instruction Manual

3 Short-Range Comms & IoT Mode
3.7 ACP Measurement
[:SENSe]:ACPower:CARRier[1]|2:AUTO[:STATe]?
Subopcode: 1 = BTS/Downlink (Default), 2 = MS/Uplink
Example
:ACP:CARR:AUTO OFF
:ACP:CARR:AUTO?
Preset
ON
State Saved Saved in instrument state
Range Auto | Man
Backwards
Compatibility
SCPI
[:SENSe]:MCPower:CARRier[1]|2:AUTO[:STATe]
Total Power Ref
Sets manual total power reference.
This control has two different forms, depending on the currently-selected Mode:
–
"Total Power Ref (Modes: SA, WCDMA, VMA, SRComms)" on page 952
–
"Total Power Ref (Modes: LTEAFDD, LTEATDD, 5G NR, MSR)" on page 953
Total Power Ref (Modes: SA, WCDMA, VMA, SRComms)
This is used when Power Ref is Manual and "Measurement Type" on page 947 is
Total Power.
Remote Command
[:SENSe]:ACPower:CARRier[1]|2[:POWer] <real>
[:SENSe]:ACPower:CARRier[1]|2[:POWer]?
Subopcode: 1 = BTS/Downlink (Default), 2 = MS/Uplink
Example
:ACP:CARR 10
:ACP:CARR?
Notes Although the default value is defined, the value is recalculated by the measurement result just after
measurement
Note that Carrier subopcode 2 is not supported in some Modes. In those cases, Carrier subopcode 1 is
used for both BTS and MS and commands with subopcode 2 are accepted without error but ignored
The Unit Terminators differ depending on whether or not the mode supports Y Axis Unit and also
which Y Axis Unit is selected
Dependencies Available only when Measurement Type is TPRef, otherwise grayed-out
Preset 0.0
State Saved Saved in instrument state
952 Short Range Comms & IoT Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)