4 System
4.2 I/O Config
:LXI:IDENtify[:STATe]?
Example
:LXI:IDEN ON
Preset Not part of Preset, but reset to OFF by Restore Defaults >"All" on page 1799
State Saved No
Range
OFF | ON
4.2.6 Restore I/O Config Defaults
Causes the group of settings associated with the I/O Config menu to be reset to
their default values. This also happens on Restore Misc Defaults, which has a SCPI
command.
When Restore I/O Config Defaults is selected, a message appears saying:
This will reset all of the I/O Config variables to their default state,
including the GPIB address and SCPI LAN settings
It will not affect Alignment data or settings
This action cannot be undone. Do you want to proceed?
The message provides OK and Cancel buttons so you can affirm or cancel the
operation.
4.2.7 Query USB Connection (Remote Query Only)
Enables you to determine the speed of the USB connection.
Remote
Command
:SYSTem:COMMunicate:USB:CONNection?
Example
:SYST:COMM:USB:CONN?
Notes
NONE
Indicates no USB connection has been made
LSPeed
Indicates a USB low speed connection (1.5 Mbps)
Note that this is reserved for future use, the T+M488 protocol is not supported
on low-speed connections
HSPeed
Indicates that a USB high speed connection (480 Mbps) has been negotiated
FSPeed
Indicates that a USB full speed connection (12 Mbps) has been negotiated
State Saved No
Range
NONE | LSPeed | HSPeed | FSPeed
1761 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
