9 Programming the Instrument
9.4 Status Register System & STATus Subsystem
Bit Condition Operation
0 Align RF
skipped
During an alignment, the calibration of the RF section (frontend) of the
instrument was not performed. This can be caused by an interfering
user signal present at the RF Input
See "Align Now" on page 1806, "Align Now All" on page 1808
Filter Registers
–
"Questionable Calibration Skipped Condition" on page 2495
–
"Questionable Calibration Skipped Enable" on page 2496
–
"Questionable Calibration Skipped Event Query" on page 2496
–
"Questionable Calibration Skipped Negative Transition" on page 2496
–
"Questionable Calibration Skipped Positive Transition" on page 2497
Questionable Calibration Skipped Condition
Returns the decimal value of the sum of the bits in the Questionable Calibration
Skipped Condition register.
NOTE
The data in this register is continuously updated and reflects the current
conditions.
Remote
Command
:STATus:QUEStionable:CALibration:SKIPped:CONDition?
Example
:STAT:QUES:CAL:SKIP:COND?
Preset 0
Status Bits/OPC
dependencies
Sequential command
2495 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
