Keysight x-series Instruction Manual

6 Input/Output
6.1 RF Source
Remote Command
:SOURce:RADio:ARB:TRIGger:SYNC[:STATe] ON | OFF | 1 | 0
:SOURce:RADio:ARB:TRIGger:SYNC[:STATe]?
Example
:SOUR:RAD:ARB:TRIG:SYNC ON
:SOUR:RAD:ARB:TRIG:SYNC?
Notes Compensates for the instrument internal latency. The negative trigger delay compensates the external
latency (that is, heads and cables). See "External Trigger Delay" on page 1990 and "PXI Trigger Delay"
on page 1993
The first PerARB trigger is cut off if Sync to Trigger Source is ON
Dependencies Only available when "Trigger Source" on page 1988 is EXTernal1, EXTernal2, or PXI
Preset
OFF
Range
ON|OFF
External Trigger Delay
Lets you toggle the state and value of external trigger delay. The value you enter
sets a delay time between when an external trigger is received and when it is
applied to the waveform. Only active if "Trigger Source" on page 1988 is EXTernal1
or EXTernal2.
Negative trigger delay is only supported by VXT models M9410A/11A/15A/16A and
M9410E/11E/15E/16E (see "More Information" on page 1991).
Remote Command
:SOURce:RADio:ARB:TRIGger[:SOURce]:EXTernal:DELay <time>
:SOURce:RADio:ARB:TRIGger[:SOURce]:EXTernal:DELay?
Short Range Comms & IoT Mode User's &Programmer's Reference 1990

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)