To Next Page

To Previous Page

7 Save/Recall/Print

7.2 Recall

:MMEM:LOAD:EVM:REC:CHAN?

Preset

ALL

State Saved No

Range

ALL|CH1|CH2|CH3|CH4|CH5|CH6|CH7|CH8

7.2.34 Reset

Clears all recalled data channels.

This is only supported by 5GNR EVM, VMA Digital Demod, VMA Custom OFDM and

WLAN MIMO EVM measurements.

The <meas> param in the command must be replaced with the node of the active

measurement:

–

EVM for 5GNR EVM

–

EVMM for WLAN MIMO EVM

–

DDEM for VMA Digital Demod

–

OFDM for VMA Custom OFDM

Remote

Command

:MMEMory:LOAD:<meas>:RECording:RESet

Example

:MMEM:LOAD:EVM:REC:RES

7.2.35 Recalled data channel table (Display only)

Displays recalled IQ data file for each channel in a table.

7.2.36 CC Setup

You can recall a Component Carrier Setup file, which sets up the 5G NR Modulation

Analysis measurement with the settings in the file.

Using the Component Carrier dropdown, you can specify which component carrier

you wish to apply this setup to, or ALL.

The following file formats are supported:

Format Extension

Signal Studio N7631C Setup

.scp

2246 Short Range Comms & IoT Mode User's &Programmer's Reference

Keysight x-series Instruction Manual

Other manuals for Keysight x-series