Keysight x-series Instruction Manual

8 Trigger
8.1 Trigger
The Trigger tab contains the following Trigger Source dependent controls when
External 1 Trigger is selected:
–
"Prot Frame Aligned" on page 2340
–
"Trigger Delay" on page 2343
–
"Trigger Slope" on page 2347
Additional controls are also present that are not dependent on the selected Trigger
Source.
Example
:TRIG:SOUR EXT1
Swept SA measurement
:TRIG:<meas>:SOUR EXT1
Measurements other than Swept SA
Annunciation External 1 (in the Meas Bar)
8.1.1.6 External 2
When External 2 is selected, a new sweep/measurement starts when the external
trigger condition is met using the TRIGGER 2 IN input connector on the rear panel.
Grayed-out if Ext 2 is in use by Point Trigger in the Source Setup menu of Swept SA.
Forced to "Free Run" on page 2328 if already selected and Point Trigger is set to
External 2.
The Trigger tab contains the following Trigger Source dependent controls when
External 2 Trigger is selected:
–
"Prot Frame Aligned" on page 2340
–
"Trigger Delay" on page 2343
–
"Trigger Slope" on page 2347
Additional controls are also present that are not dependent on the selected Trigger
Source.
Example
:TRIG:SOUR EXT2
Swept SA measurement
:TRIG:<meas>:SOUR EXT2
Measurements other than Swept SA
Annunciation External 2 (in the Meas Bar)
2331 Short Range Comms & IoT Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)