To Next Page

To Previous Page

9 Programming the Instrument

9.4 Status Register System & STATus Subsystem

9.4.6.5 Questionable Register

This register and the "Operation Register" on page 2465 monitor the overall

instrument condition. They are accessed using :STATus:OPERation and

:STATus:QUEStionable.

This register monitors the instrument’s condition to see if anything questionable has

happened. It detects anything that might cause an error or a bad measurement,

such as a hardware problem, an out-of-calibration situation, or a unusual signal. All

the bits are summary bits from lower-level event registers.

Bit Condition Operation

3 Power summary Summary bit for "Questionable Power Register" on page 2475

4 Temperature

summary

Summary bit for "Questionable Temperature Register" on page

2478

5 Frequency summary Summary bit for "Questionable Frequency Register" on page

2481

8 Calibration summary Summary bit for "Questionable Calibration Register" on page

2484

9 Integrity summary Summary bit for "Questionable Integrity Register" on page 2497

Filter Registers

–

"Questionable Condition" on page 2473

–

"Questionable Enable" on page 2473

–

"Questionable Event Query" on page 2474

–

"Questionable Negative Transition" on page 2474

–

"Questionable Positive Transition" on page 2474

Short Range Comms & IoT Mode User's &Programmer's Reference 2472

Keysight x-series Instruction Manual

Other manuals for Keysight x-series