Keysight x-series Instruction Manual

6 Input/Output
6.2 Input
Mixer Readout on setup dialog and menu panel Harm # RF start RF stop RF center
D-band D-band Single Harmonic w/doubler -14 110 170 140
F-band F-band Single Harmonic w/doubler -10 90 140 115
G-band G-band Single Harmonic w/doubler -16 140 220 180
J-band J-band Single Harmonic w/doubler -24 220 325 272.5
K-band K-band Single Harmonic w/doubler -2 18 26.5 22.25
Q-band Q-band Single Harmonic w/doubler -4 33 50 41.5
V-band V-band Single Harmonic w/doubler -6 50 75 62.5
W-band W-band Single Harmonic w/doubler -8 75 110 92.5
Y-band Y-band Single Harmonic w/doubler -20 170 260 215
Extended Extended Single Harmonic w/doubler -28 245 390 317.5
Multiple Harmonics
These presets select a setup that uses multiple harmonics and may or may not use
doubling for the LO.
Mixer Readout on setup
dialog and menu
panel
Range Harm # Dblr? RF start RF stop RF Center
A-band A-band Multiple
Harmonic
1 -4 N 26.5 34.1 30.3
2 -4 Y 33.1 40 36.55
E-band E-band Multiple
Harmonic
1 -6 Y 60 83 71.5
2 -8 Y 65 90 77.5
U-band U-band Multiple
Harmonic
1 -6 N 40 51.5 45.75
2 -6 Y 49.5 60 54.75
Coaxial Coaxial Multiple
Harmonic
1 -4 N 26.5 34 30.25
2 -4 Y 32.5 55 43.75
3 -6 Y 50 70 60
6.2.13.2 Mixer Bias
Adjusts an internal bias source for use with external mixers. The bias signal is
present on the center conductor of the IF input connector on the front panel. The
shunt current range is from -10mA to 10mA, and it can be set whether Mixer Bias
state is On or Off, but it will only be applied if it is On.
The bias remains as set if you switch to another input (for example, the RF Input).
Remote
Command
[:SENSe]:MIXer:BIAS <real>
[:SENSe]:MIXer:BIAS?
Short Range Comms & IoT Mode User's &Programmer's Reference 2062

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)