Keysight x-series Instruction Manual

3 Short-Range Comms & IoT Mode
3.11 IQ Waveform Measurement
Backwards Compatibility SCPI Command
Sets or queries the state of a marker. Setting a marker that is OFF to state ON or 1
puts it in POSition mode and places it at the center of the screen.
Preset
OFF
State Saved Saved in instrument state
Range
OFF|ON
Backwards
Compatibility
SCPI
:CALCulate:WAVeform:MARKer[1]|2|…|12:STATe OFF | ON | 0 | 1
:CALCulate:WAVeform:MARKer[1]|2|…|12:STATe?
Delta Marker (Reset Delta)
Pressing this control has the same effect as pressing the DELTa selection in "Marker
Mode" on page 1583. The selected marker becomes a Delta marker. If the selected
marker is already a Delta marker, the reference marker is moved to the current
position of the selected marker, thus resetting the delta to zero.
Marker Settings Diagram
Lets you configure the Marker system using a visual utility.
All Markers Off
Turns off all markers.
Remote
Command
:CALCulate:WAVeform:MARKer:AOFF
Example
:CALC:WAV:MARK:AOFF
Couple Markers
When this function is ON, moving any marker causes an equal X-Axis movement of
every other marker that is not OFF. By “equal X-Axis movement” we mean that we
preserve the difference between each marker’s X-Axis value (in the fundamental x-
axis units of the trace that marker is on), and the X-Axis value of the marker being
moved (in the same fundamental x-axis units).
This may result in markers going off-screen.
Remote
Command
:CALCulate:WAVeform:MARKer:COUPle[:STATe] ON | OFF | 1 | 0
:CALCulate:WAVeform:MARKer:COUPle[:STATe]?
1584 Short Range Comms & IoT Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)