To Next Page

To Previous Page

3 Short-Range Comms & IoT Mode

3.5 Channel Power Measurement

3.5.10 Trace

Lets you control the acquisition, display, storage, detection and manipulation of

trace data for the available traces. The Trace Control tab of this menu contains

radio-button selections for the trace type (Clear/Write, Trace Average, Max Hold,

Min Hold) and View/Blank setting for the selected trace.

3.5.10.1 Select Trace

Specifies the selected trace, which is the trace that will be affected when you

change trace settings.

Select Trace appears above the menu panel, indicating that it applies to all controls

in the menu panel. Select Trace is blanked if you select a tab whose controls do not

depend on the selected trace (for example, Trace Function).

Notes The selected trace is remembered even when not in the Trace menu

Dependencies For the Swept SA measurement:

–

In Image Suppress mode, when you select a trace it becomes the active trace, and the formerly

active trace goes into View

–

When you turn on Image Suppress, Update turns off for all traces except the selected trace

For the ACP measurement, when Meas Method is RBW, FAST or FPOWer, Select Trace is disabled

Preset Trace 1

State Saved Yes

3.5.10.2 Trace Control

The controls on this tab allow you to set the "Trace Type" on page 1731 and its

update mode.

There are four Trace Types:

–

Clear/Write

–

Trace Average

–

Max Hold

–

Min Hold

Each type handles data in a different way.

Short Range Comms & IoT Mode User's &Programmer's Reference 663

Keysight x-series Instruction Manual

Other manuals for Keysight x-series