9 Programming the Instrument
9.3 SCPI Operation and Results Query
Specifies the number of points that will be smoothed. Increasing the number of
points increases smoothing at the cost of decreasing resolution. If the number of
points is an even number, then the number of points is increased by one. If the
number of points is larger than the number of sweep points, then the number of
sweep points is used, unless the number of sweep points is even, in which case the
number of points will be the sweep points minus one. The number of points
smoothed is always an odd number.
Example
:TRAC:MATH:SMO:POIN 501
Notes Only odd values are allowed
If an even value of <integer> is specified, adds 1 unless <integer> = number of sweep points, in
which case subtract 1
Used with TRACe:MATH:SMOoth
Preset 11
Min 3
Max Number of sweep points
Backwards
Compatibility
SCPI
:TRACe:MATH:SMOoth:POINts <integer>
:TRACe:MATH:SMOoth:POINts?
9.3.3.9 Mean Trace Data (Remote Command Only)
Included for ESA compatibility. Not recommended for new designs. Use
:CALCulate:DATA:COMPress instead.
Returns the mean of the amplitudes of the trace amplitude elements in
measurement units.
Example
:TRAC:MATH:MEAN? TRACE2
Backwards Compatibility
SCPI
:TRACe:MATH:MEAN? TRACE1 | … | TRACE6
2449 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
