3 Short-Range Comms & IoT Mode
This mode enables the instrument to automatically make the following
measurements. The detailed results displayed by the measurements enable you to
analyze ZigBee (IEEE 802.15.4) ,Z-Wave (ITU-T G.9959), and LoRa
TM
CSS system
performance. You may alter the measurement parameters for specialized analysis.
Channel Power
Adjacent Channel Power (ACP or ACLR)
Spectrum Emission Mask
Power Stat CCDF
Modulation Analysis
LoRa CSS Demod
Occupied Bandwidth
Spurious Emissions
Monitor Spectrum
IQ Waveform
HRP UWB Demod
Example
:INST:SEL SRCOMMS
:INST:NSEL 218
Dependencies The mode must be installed and licensed in your instrument before it is available for use. The model
number of the mode is N9084C
Status Bits/OPC
dependencies
Changing modes resets all SCPI status registers and mask registers to their power-on defaults.
Therefore, event or condition register masks must be re-established after a mode change
X-Series Signal Analyzers
Short Range Comms & IoT Mode User's &Programmer's Reference
179
To Next Page
Loading...
Need help?
General
