7 Save/Recall/Print
7.3 Save
or rear panel USB ports. On instruments with PC6 or PC7 CPUs, one SD card slot is
available for removable media. The instrument’s primary disk drive is not a
removable media device.
Remote
Command
:MMEMory:RMEDia:LIST?
Example
:MMEM:RMED:LIST?
Notes The return value is a string containing a list of partition identifiers, which are removable media devices.
Each identifier will be separated by a comma. If no removable media is present, an empty string is
returned
Examples:
–
One removable device present results in a return string of “F:”
–
Two removable devices present results in a return string of “F:,G:”
No removable devices present results in a return string of “”
7.3.68 Mass Storage Determine Removable Media Label (Remote Command
Only)
Used to set or query a removable media device’s label.
Remote
Command
:MMEMory:RMEDia:LABel
<partition>,<string>
:MMEMory:RMEDia:LABel?
<partition>
Example
:MMEM:RMED:LAB "F:","My Device"
Notes If the <partition> specified does not exist or is not a removable media device, the error -252,
”Missing Media” is generated
Setting the removable media label requires Administrative privileges. If the currently logged-in user
does not have appropriate privileges, error “-221, Settings conflict; Administrator privileges required” is
generated
7.3.69 Mass Storage Determine Removable Media Write-protect status
(Remote Query Only)
Used to query a removable media device’s write-protect status.
Remote
Command
:MMEMory:RMEDia:WPRotect?
<partition>
Example
:MMEM:RMED:WPR? "F:"
Notes The return value is 1 if the device is write-protected, and 0 if the device is write-enabled
If the <partition> specified does not exist or is not a removable media device the error -252,
”Missing Media” is generated
Preset The return value depends on the SD card installed
Short Range Comms & IoT Mode User's &Programmer's Reference 2309
To Next Page
Loading...
Need help?
General
