4 System
4.2 I/O Config
Factory
SCPI example: :SYST:IDN:CONF FACT
Selects the factory default configuration of *IDN?, which indicates the Manufacturer
as Keysight Technologies. For example,
“Keysight Technologies,N9040B,MY00012345,A.15.00”
where the fields are Manufacturer, Model Number, Serial Number, Firmware
Revision.
NOTE
In products that run multiple instances of the X-Series Application, all instances
use the
same
factory System IDN response.
Agilent
SCPI example: :SYST:IDN:CONF AGIL
Starting with software version x.14.50, the *IDN? response in the Factory
configuration indicates the Manufacturer as Keysight Technologies. If your test
software is expecting the response to indicate Agilent Technologies, you can
configure the response with this menu selection or SCPI command.
For example:
“Agilent Technologies,N9020A,MY00012345,A.05.01”
NOTE
In products that run multiple instances of the X-Series Application, all instances
use the
same
Agilent System IDN response.
User
SCPI example: :SYST:IDN:CONF USER
Selects your customized configuration of *IDN?
Enter your desired response using "User IDN" on page 1757.
4.2.4.2 User IDN
Allows you to specify your own response to *IDN?. You may enter your desired
response with the Alpha Editor or a plugin PC keyboard. Once the value is entered,
select USER under System IDN Response.
When you select this control, the active function becomes the current User string
and is highlighted, so typing replaces it. If instead you wish to edit the existing
string, press the left or right arrow to go to the beginning or the end.
1757 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
