To Next Page

To Previous Page

3 Short-Range Comms & IoT Mode

3.10 Spurious Emissions Measurement

Preset

OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF,

OFF, OFF, OFF, OFF, OFF

State Saved Saved in instrument state

Range Low | High

Enabled

Same as the Enabled checkbox under the Bandwidth tab. See "Enabled" on page

1432.

Res BW

Same as the Enabled checkbox under the Bandwidth tab. See"Res BW" on page

1440.

Meas BW

Same as the Meas BW column under the Bandwidth tab. See"Meas BW" on page

1442.

Video BW

Sets the Video BW mode of the instrument. This can be Auto, where the instrument

determines the optimum setting, or Manual, where you determine the setting. This

parameter can send up to 20 values. The location in the list sent corresponds to the

range the value is associated with. When sending the remote command, missing

values are not permitted; that is, if you want to change values 2 and 6, then you

must send all values up to 6. Subsequent values will remain as they were.

The query always returns 20 values.

Remote

Command

[:SENSe]:SPURious[:RANGe][:LIST]:BANDwidth:VIDeo <freq>, <freq>, <freq>,

<freq>, <freq>, <freq>, <freq>, <freq>, <freq>, <freq>, <freq>, <freq>,

[:SENSe]:SPURious[:RANGe][:LIST]:BANDwidth:VIDeo?

Example

:SPUR:BAND:VID 1kHz, 10kHz, 100kHz, 1MHz, 1MHz, 1MHz, 1MHz, 3MHz, 3MHz,

3MHz, 3MHz, 3MHz, 3MHz, 3MHz, 3MHz, 3MHz, 3MHz, 3MHz, 3MHz, 3MHz

:SPUR:BAND:VID?

Preset SA, WCDMA, WLAN Modes: Automatically calculated

LTE, LTEAFDD, MSR Modes: 4.7kHz, 47kHz, 470kHz, 5MHz, 470kHz, 5MHz, 5MHz, 300kHz, 300kHz,

300kHz, 300kHz, 300kHz, 300kHz, 300kHz, 300kHz, 300kHz, 300kHz, 300kHz, 300kHz, 300kHz

LTETDD, LTEATDD Modes:

Short Range Comms & IoT Mode User's &Programmer's Reference 1453

Keysight x-series Instruction Manual

Other manuals for Keysight x-series