3 Short-Range Comms & IoT Mode
3.10 Spurious Emissions Measurement
it was on to the new trace. If the marker is OFF, it stays off but is now associated with
the specified trace.
The query returns the number of the trace on which the marker is currently placed.
Remote
Command
:CALCulate:SPURious:MARKer[1]|2|…|12:TRACe:ATTached TRACe1 | TRACe2 | TRACe3
:CALCulate:SPURious:MARKer[1]|2|…|12:TRACe:ATTached?
Example
:CALC:SPUR:MARK2:TRAC:ATT TRAC2
:CALC:SPUR:MARK2:TRAC:ATT?
Notes A marker may be placed on a blanked and/or inactive trace, even though the trace is not visible and/or
updating
An application may register a trace name to be displayed on the control instead of a trace number
Couplings The state of Marker Trace is not affected by "Auto Couple" on page 1709
Sending the remote command causes the addressed marker to become selected
Preset
TRACe1
State Saved Saved in instrument state
Range
TRACe1|TRACe2|TRACe3
Marker Settings Diagram
Lets you configure the Marker system using a visual utility. It is the same as "Marker
Settings Diagram" on page 1421 under Settings.
3.10.8 Meas Setup
Contains functions for setting up the measurement parameters, and for setting up
parameters global to all measurements in the Mode.
3.10.8.1 Settings
Contains frequently-used Meas Setup functions, to which you will want the fastest
access.
Avg/Hold Num
Specifies the number of measurement averages used to calculate the measurement
result. The average is displayed at the end of each sweep.
Remote
Command
[:SENSe]:SPURious:AVERage:COUNt <integer>
[:SENSe]:SPURious:AVERage:COUNt?
Example
:SPUR:AVER:COUN 2500
1426 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
