Keysight x-series Instruction Manual

6 Input/Output
6.9 Calibration
6.9.1.15 Insert Row Below
Adds a new row to the currently selected Cal Group, under the currently selected
row in the table or after the sub opcode used in the SCPI command. The default
values for each of the settings in the row is used.
Remote Command
:SYSTem:CALibration:ROW[1]|2|…|100:INSert
Example
:SYST:CAL:ROW2:INSert
Dependencies The SCPI command is applied to the currently selected Cal Group. The subopcode is used to identify
the Cal row in the Cal Group
If the subopcode does not reference an existing Cal row in the Cal Group, the error message “-221,
Settings conflict; Subopcode does not reference an existing Cal row” is generated
6.9.1.16 Description
Provides a description for the currently selected Cal Group from which the operator
can easily identify the Cal Group.
Remote Command
:SYSTem:CALibration:DESCription "Description"
:SYSTem:CALibration:DESCription?
Example
:SYST:CAL:DESC "Description"
Notes Also shown on the Calibration menu panel, but limited to the first 18 characters
Dependencies The SCPI command is applied to the currently selected Cal Group
State Saved Saved in instrument state
6.9.1.17 Use Current Meas
Takes the settings from the current running measurement state to populate the Cal
Row settings of the currently selected Cal Group.
Remote Command
:SYSTem:CALibration:ROW[1]|2|…|100:UCMeas
Example
:SYST:CAL:ROW2:UCM
Dependencies The SCPI command is applied to the currently selected Cal Group. The subopcode is used to identify
the Cal row in the Cal Group
If the group table is empty and subopcode is omitted or 1, a new row is created and populated using
the current running measurement
If the subopcode does not reference an existing Cal row in the Cal Group, the error message “-
221,Settings conflict; Subopcode does not reference an existing Cal row” is generated
Pressing the control or sending the SCPI command in measurements that do not support this
parameter generates error -221, “Settings conflict; Feature not supported for this measurement”
2187 Short Range Comms & IoT Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)