Keysight x-series Instruction Manual

3 Short-Range Comms & IoT Mode
3.12 Monitor Spectrum Measurement
global settings use the Global Center Frequency, so you can switch between any of
these Modes and the Center Frequency remains unchanged.
Adjusting the Center Frequency of any Mode that supports Global Settings, while
Global Center Freq is ON, modifies the Global Center Freq.
When Global Center Freq is switched OFF, the Center Frequency of the current
Mode is unchanged, but now the Center Frequency of each Mode is once again
independent.
When Mode Preset is pressed while Global Center Freq is ON, the Global Center Freq
is preset to the preset Center Frequency of the current Mode.
This function resets to OFF when "Restore Defaults" on page 1719 is pressed, or
when System, Restore Defaults, All Modes is pressed.
Remote
Command
:INSTrument:COUPle:FREQuency:CENTer ALL | NONE
:INSTrument:COUPle:FREQuency:CENTer?
Example
:INST:COUP:FREQ:CENT ALL
:INST:COUP:FREQ:CENT?
Preset Set to OFF on Global Settings, Restore Defaults and System, Restore Defaults, All Modes
Range
ALL|NONE
Preset
OFF
Backwards Compatibility
SCPI
:GLOBal:FREQuency:CENTer[:STATe] 1 | 0 | ON | OFF
:GLOBal:FREQuency:CENTer[:STATe]?
Global EMC Std
When this control is switched ON, the current Mode’s EMC Std is copied into the
Global EMC Std, and from then on all Modes that support global settings use the
Global EMC Std, so you can switch between any of these Modes and the EMC Std
remains unchanged.
Adjusting the EMC Std of any Mode that supports Global settings, while Global EMC
Std is ON modifies the Global EMC Std.
When Global EMC Std is switched OFF, the EMC Std of the current Mode remains
unchanged, but now the EMC Std of each Mode is once again independent. When
Mode Preset is pressed while Global EMC Std is ON, Global EMC Std is preset to the
preset EMC Std of the current Mode.
This function resets to OFF when "Restore Defaults" on page 1719 is pressed, or
when System, Restore Defaults, All Modes is pressed.
Remote Command
:INSTrument:COUPle:EMC:STANdard ALL | NONE
:INSTrument:COUPle:EMC:STANdard?
1718 Short Range Comms & IoT Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)