Keysight x-series Instruction Manual

9 Programming the Instrument
9.4 Status Register System & STATus Subsystem
The variable <integer> is the sum of the decimal values of the bits that you want to
enable.
Remote
Command
:STATus:QUEStionable:POWer:PTRansition <integer>
:STATus:QUEStionable:POWer:PTRansition?>
Example
:STAT:QUES:POW:PTR 32
Source Unlevelled being set will be reported to the Power Summary of the Status Questionable
register
Preset 32767
Min 0
Max 32767
Status Bits/OPC
dependencies
Sequential command
9.4.6.7 Questionable Temperature Register
Monitors temperature-related conditions within the instrument and summarizes
them in bit 4 of the "Questionable Register" on page 2472.
Bit Condition Operation
0 Reference Oscillator
Oven Cold
(not currently in use)
1 Instrument overheated
(over temperature)
Excessive heat has been detected in some part of the
instrument
2 Instrument over current Excessive heat has been detected in some part of the
instrument, the instrument should be restarted
Filter Registers
–
"Questionable Temperature Condition" on page 2479
–
"Questionable Temperature Enable" on page 2479
Short Range Comms & IoT Mode User's &Programmer's Reference 2478

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)