3 Short-Range Comms & IoT Mode
3.12 Monitor Spectrum Measurement
Couplings “Preset to Std” will set “Radio Standard” accordingly
Preset ZIGB
State Saved Yes
Range 802.15.4(ZigBee) | Z-Wave | LoRa CSS | 802.15.4(HUwb)
Standard Compatibility
ZigBee (IEEE 802.15.4)
Z-Wave (ITU-T G.9959)
LoRa
TM
CSS HRP UWB
Channel Power Yes Yes No
ACP Yes No No
SEM Yes No Yes
OBW Yes Yes No
Spurious Emissions Yes Yes No
CCDF Yes Yes No
IQ Waveform Yes Yes No
Monitor Spectrum Yes Yes No
Modulation Analysis (Digital) Yes No No
LoRa CSS Demod (Analog) No Yes No
Preset to Std
This group of controls lets you easily set up the analyzer for ZigBee (IEEE 802.15.4),
Z-Wave (ITU-T G.9959) , LoRa
TM
CSS or HRP UWB measurements.
Remote Command
[:SENSe]:RADio:STANdard:PRESet ZIGBEE2450 | ZIGBEE915 | ZIGBEE868 |
ZBOQPSK780 | ZBOQPSK915 | ZBOQPSK868 | ZWAVER1 | ZWAVER2 | ZWAVER3 | LORA7K
| LORA10K | LORA15K | LORA20K | LORA31K | LORA41K | LORA62K | LORA125K |
LORA203K | LORA250K | LORA406K | LORA500K | LORA812K | LORA1625K | HUWB500M
Example
:RAD:STAN:PRES ZIGBEE2450
Activates the preset for ZigBee 2450
Notes “Preset to Standard” was re-designed using cascading list dialog in XA25, thus all radio standards and
the associated preset options are accessible at one time (prior to XA25, users need to select Radio
Standard first, then select “preset to standard” which were conditionally shown according to the
selected radio standard.)
The selected Radio Standard and Preset results are displayed on the top of Meas Standard menu
panel
Dependencies “Preset to Std” will set “Radio Standard” accordingly, though it was changed to a SCPI only setting for
backward compatibility
Range 802.15.4 OQPSK 2450 MHz | 802.15.4 BPSK 915 MHz | 802.15.4 BPSK 868/950 MHz | 802.15.4
OQPSK 780 MHz | 802.15.4 OQPSK 915 MHz | 802.15.4 OQPSK 868 MHz | Z-Wave R1 (9.6 kbps) FSK |
Z-Wave R2 (40 kbps) FSK | Z-Wave R3 (100kbps) GFSK | LoRa CSS 7.815 kHz| LoRa CSS 10.4167 kHz|
1712 Short Range Comms & IoT Mode User's &Programmer's Reference