5 Preset
5.10 User Preset All Screens
5.10 User Preset All Screens
Recalls a screen configuration previously saved using "Save User Preset All
Screens" on page 1913. The complete configuration of all Screens is loaded,
including the state of each Screen.
Because User Preset All Screens performs a Recall State as part of its function, it
affects all variables that are normally only reset by "Restore Mode Defaults" on page
1904, and affects Input/Output variables, because both are included in State files.
Note that recalling a screen configuration in this manner wipes out your current
screen configuration, and all states of all Screens.
Notes "Save User Preset All Screens" on page 1913 is used to save the current screen configuration as the
“user preset all screens” configuration
If loading a User Preset All Screens file from a different instrument, some settings may be limited
and/or coupled differently, since the capabilities of the Mode may have changed from when the User
Preset All Screens file was saved
Status Bits/OPC
dependencies
Clears all pending OPC bits
The Status Byte is set to 0
Short Range Comms & IoT Mode User's &Programmer's Reference 1912
To Next Page
Loading...
Need help?
General
