To Next Page

To Previous Page

6 Input/Output

6.1 RF Source

Backwards Compatibility

SCPI

:SOURce:LIST:TRIGgerout:TYPe:Marker

6.1.8.6 Manual Trigger Now

Provides a software trigger event to the List Sequencer. During execution of a

sequence, if the sequencer is halted on any step that has been configured with a

“Manual” step trigger, then this keypress causes the sequencer to continue and

execute the step.

Notes No remote command, front panel only

6.1.8.7 List Sequencer Setup

Accesses the List Sequencer setup menus.

Number of Steps

Lets you specify the number of steps within the list sequence.

Remote Command

:SOURce:LIST:NUMBer:STEPs <integer>

:SOURce:LIST:NUMBer:STEPs?

Example

:SOUR:LIST:NUMB:STEP 1

Notes Increasing the number of steps creates additional steps at the end of the list, with all the settings

within the steps set to their default values

Decreasing the number of steps removes steps from the end of the list. The settings within the

removed steps are not reset. This means that increasing the number of steps again would allow you to

retrieve these steps

Dependencies The Step Count parameter is increased or decreased when you insert or delete a point from within the

GUI interface to the sequencer

Not available in E7760B

Preset 1

Min 1

Max 1000

Go To Step

Lets you select the step number you wish to view or edit.

Preset 1

Short Range Comms & IoT Mode User's &Programmer's Reference 1934

Keysight x-series Instruction Manual

Other manuals for Keysight x-series