6 Input/Output
6.1 RF Source
Delete Segment From ARB Mem
This is the same as Delete Segment From ARB Mem in the Recall, Waveform dialog.
Delete All From ARB Memory
This is the same as Delete All From ARB Memory in the Recall, Waveform dialog.
Delete Segment
Lets you delete the selected segment from the waveform sequence.
Save Sequence
Lets you save the newly built Waveform Sequence to the disk drive.
Sequence files have the extension .seq. The default filename is WfmSequence_
0000.seq, where the 4-digit number is the lowest number that does not conflict
with any filename in the current directory. Use “File Name” and “File Type’ to specify
your waveform sequence. The newly build sequence will be stored in the current
directory.
Build New Sequence (Remote Command Only)
This is the SCPI equivalent of the waveform sequence creation features described in
"Build New Sequence" on page 2002.
Writes a waveform sequence file to the hard disk. You must specify the waveform
sequence file path and filename which will be saved on the hard disk, and the
waveform segment file path and name which will be nested into the waveform
sequence file. You can utilize mass storage unit specifier (MSUS) “NVWFM” or use a
real full path representation. See the example below. MSUS “NVWFM” is mapped to
D:\NVARB directory on test set hard disk.
Any number of segments, up to a segment count limit of 64, can be used to create a
sequence. Repeated segments are included in the count limit.
Each waveform segment name string length upper limit is 128 chars. Do not attempt
to insert a waveform with a name string that exceeds 128 chars.
The internal source does not support nesting one waveform sequence file into
another waveform sequence file.
Remote
:SOURce:RADio:ARB:SEQuence[:MWAVeform] <filename>, <waveform1>, <reps>, NONE
2005 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
