3 Short-Range Comms & IoT Mode
3.7 ACP Measurement
:ACP:CARR2:LIST:METH?
Notes Maximum of Array length depends on the number of carriers
Couplings This command is an alias of:
[:SENSe]:ACPower:CARRier[1]|2:LIST:FILTer[:RRC][:STATe]
The enum value translates as follows:
–
RRC Weighted = 1|ON
–
Integ BW = 0|OFF
Maximum of Array length depends on the number of carriers
Preset
Modes Value
SA
IBW
WCDMA
RRC
LTEAFDD, LTEATDD, MSR
IBW
State Saved Saved in instrument state
Backwards
Compatibility
SCPI
[:SENSe]:ACPower:CARRier[1]|2:LIST:METHod IBW | RRC, …
[:SENSe]:ACPower:CARRier[1]|2:LIST:METHod?
3.7.14 Sweep
Accesses controls to configure and control the acquisition of data, and the X-axis
parameters of the instrument.
Depending on the selected mode and measurement, these controls might include:
Sweep Time, Continuous/Single, Pause/Resume, X Scale and Number of Points.
3.7.14.1 Sweep/Control
Accesses controls that let you operate the sweep and control functions of the
instrument, such as Sweep Time and Continuous/Single.
Sweep Time
Controls the time the instrument takes to sweep the current frequency span in
swept measurements, displays the sweep time in swept measurements, and
displays the equivalent Sweep Time in FFT measurements.
When Sweep Time is in Auto, the instrument computes a time that will give accurate
measurements based on other settings, such as RBW and VBW.
Short Range Comms & IoT Mode User's &Programmer's Reference 975
To Next Page
Loading...
Need help?
General
