3 Short-Range Comms & IoT Mode
3.12 Monitor Spectrum Measurement
3.12 Monitor Spectrum Measurement
The Monitor Spectrum measurement provides a quick, convenient means of looking
at the entire spectrum. While the look and feel are similar to Spectrum Analyzer
Mode, the functionality is greatly reduced for easy operation. The main purpose of
this measurement is to show the spectrum. The default span should cover an
appropriate frequency range of the application.
Measurement Commands
The following commands can be used to configure the measurement and retrieve
results:
:CONFigure:MONitor
:CONFigure:MONitor:NDEFault
:INITiate:MONitor
:FETCh:MONitor[n]?
:READ:MONitor[n]?
:MEASure:MONitor[n]?
Remote Command Results
The following table describes the results returned by the queries listed above,
according to the index value n.
n Results Returned
1 (or not specified) Returns trace1 data with comma separated floating numbers
2 Returns trace2 data with comma separated floating numbers
3 Returns trace3 data with comma separated floating numbers
3.12.1 Views
For modes other than MSR, LTEAFDD/LTEATDD and 5GNR, there is a single view,
Normal.
"Normal" on page 1630 This is a single window view of the spectrum
3.12.1.1 Normal
Windows: "Spectrum" on page 1631
1630 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
