Keysight x-series Instruction Manual

3 Short-Range Comms & IoT Mode
3.12 Monitor Spectrum Measurement
been selected, the query returns “AVER”
Couplings When "Detector Select Auto/Man" on page 1741 is ON, the detector selected depends on the Trace
(Average) type
Preset
NORMal
State Saved Yes
Range
AVERage|NEGative|NORMal|POSitive|SAMPle|RMS
Annotation The four letter mnemonic for the detector appears in the trace window next to the trace it applies to
Backwards
Compatibility
SCPI
[:SENSe]:MONitor:DETector[:FUNCtion]
Applied to Trace 1 only
Detector Select Auto/Man
Sets the Detector mode to Auto or Manual. In Auto, the proper detector is chosen
based on rules that take into account the measurement settings and other
instrument settings.
When any detector is selected by the user, this toggles automatically set to Man
(manual).
Remote
Command
[:SENSe]:MONitor:DETector:TRACe[1]|2|3:AUTO ON | OFF | 1 | 0
[:SENSe]:MONitor:DETector:TRACe[1]|2|3:AUTO?
Example
:MON:DET:TRAC2:AUTO ON
:MON:DET:TRAC2:AUTO?
Couplings When this function is ON, the "Detector" on page 1739 and "Trace Type" on page 1731 settings
automatically align as follows:
–
“NORMal” with Clear Write
–
“AVERage” with AVERage
–
“POSitive (Peak)” with MAXHold
–
“NEGative (Peak)” with MINHold
Preset
ON
State Saved Yes
Backwards
Compatibility
SCPI
[:SENSe]:MONitor:DETector:AUTO
Applied to Trace 1 only
Short Range Comms & IoT Mode User's &Programmer's Reference 1741

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)