3 Short-Range Comms & IoT Mode
3.2 Modulation Analysis Measurement
3.2.5.1 Meas Display
The Meas Display tab contains controls for setting up the display for the current
Measurement, View or Window.
Demod/Decode Bits Format
This control enables you to choose the display format of demod bits and decode
bits: hexadecimal or binary digits.
Remote Command
:DISPlay:EVM:BITS:FORMat HEX | BINary
:DISPlay:EVM:BITS:FORMat?
Example
:DISP:EVM:BITS:FORM HEX
:DISP:EVM:BITS:FORM?
Preset BIN
State Saved Yes
Range Hex|Binary
3.2.5.2 View
Contains controls for selecting the current View, and for editing User Views.
Views
Lets you choose a View from the predefined Views for the current measurement. The
Views vary from measurement to measurement. See the “Views” section of your
measurement’s help for a list of all the Views supported by your measurement.
If you have modified the current View, using the "View Editor" on page 153, an
asterisk appears next to that View in the radio button panel. You can save the
modified View as a User View (see "Save Layout as New View" on page 1681).
246 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
