4 System
4.2 I/O Config
4.2.11.2 Config IPV4 Address (Remote Command Only)
Remote
Command
:SYSTem:COMMunicate:LAN:IPV4:CONFig <ipaddress>
:SYSTem:COMMunicate:LAN:IPV4:CONFig?
Example
:SYSTem:COMMunicate:LAN:IPV4:CONFig "192.168.1.146"
:SYSTem:COMMunicate:LAN:IPV4:CONFig?
Notes Applies to instruments that have multiple Network Adapters. When more than one network adapter is
present in the system, you must specify in the instrument config file the IP address to use to enable
Remoting channel bindings. If this is not provided, Remoting connections are likely to fail on systems
where multiple NICs are enabled
Sets the valid IPV4 address, passed in as string in the config file
The query returns IPV4 address, as a string
If config file is missing, “” (empty string) is returned
Changing the IPV4 value requires a restart of the instrument software, to ensure that servers use the
configured IP address
State Saved No
4.2.11.3 Config IPV6 Address (Remote Command Only)
Remote
Command
:SYSTem:COMMunicate:LAN:IPV6:CONFig <ipaddress>
:SYSTem:COMMunicate:LAN:IPV6:CONFig?
Example
:SYSTem:COMMunicate:LAN:IPV6:CONFig "2001:0db8:85a3:0000:0000:8a2e:0370:7334"
:SYSTem:COMMunicate:LAN:IPV6:CONFig?
Notes Applies to instruments that have multiple Network Adapters. When more than one network adapter is
present in the system, you must specify in the instrument config file the IP address to use to enable
Remoting channel bindings. If this is not provided, Remoting connections are likely to fail on systems
where multiple NICs are enabled
Sets the valid IPV6 address, passed in as string in the config file
The query returns IPV6 address, as a string
If config file is missing, “” (empty string) is returned
Changing the IPV6 value requires a restart of the instrument software, to ensure servers use the
configured IP address
State Saved No
4.2.11.4 List All Physical Network Adapter IP Addresses (Remote Query Only)
Remote
Command
:SYSTem:COMMunicate:LAN:PHYSical:IPADdress:LIST?
Example
:SYSTem:COMMunicate:LAN:PHYSical:IPADdress:LIST?
Short Range Comms & IoT Mode User's &Programmer's Reference 1768