2 User Interface
2.17 View Editor
When naming a new View, you must choose a name that is not already in use for any
User View in any measurement; this is because User Views get written to permanent
memory and are available to all instances of the Measurement in any screen. They
survive a Mode Preset and also survive shutdown and restart of the application.
Transferring User Views Between Instruments
To transfer a User View to another instrument, you must copy the desired file to a
portable drive or to your network and then copy it to the target instrument.
When you save a User View, a file is created (or updated if it already exists)
containing all the User Views for the current measurement. All of these files are
saved on the D: drive in the instrument, in the folder:
D:\Users\Instrument\My Documents\UserViews
(assuming you are logged in as Instrument, which is the default).
Look for the file for your measurement. The file naming convention is:
ModeName.MeasName.layout
Where ModeName is the long-form SCPI parameter for the :INST:SEL command for
your Mode, and MeasName is the long-form SCPI parameter for the :CONF command
for your Measurement.
For a full list of all ModeName parameters, see Index to Modes in "Mode" on page 88.
The following is a full list of all MeasName parameters.
Measurement Name SCPI ID
ACP, Adjacent Channel Power
ACPower
AM
AM
AM Depth
AMD
Amplitude Probability Distribution
APD
Audio Distortion
AUDDist
Audio Frequency
AUDFreq
Audio Level
AUDLevel
Audio SINAD
AUDSinad
Automatic Direction Finder
ADF
Channel Power
CHPower
Code Domain
CDPower
Combined GSM
CGSM
Combined WCDMA
CWCDma
Complex Spectrum
SPECtrum
Conformance EVM
CEVM
Custom OFDM
OFDM
Short Range Comms & IoT Mode User's &Programmer's Reference 169
To Next Page
Loading...
Need help?
General
