To Next Page

To Previous Page

6 Input/Output

6.2 Input

measurement that does not support it, the "No result; Meas invalid with Ext Mixing"

error condition occurs:

Mode Measurements Sig ID (Image Suppress only)

Spectrum Analyzer Swept SA Y*

TOI Y

Harmonics N

Spurious Emissions Y

Channel Power Y

Occupied BW Y

ACP Y

Spectrum Emissions Mask Y

CCDF N

Burst Power N

List Sweep N

Phase Noise Monitor Spectrum Y

Log Plot Y

Spot Frequency N

Waveform N

I/Q Analyzer Complex Spectrum N

Waveform N

Vector Signal Analyzer Vector Analysis N

Analog Demod N

Digital Demod N

Analog Demod AM N

FM N

PM N

FM Stereo N

* the Swept SA measurement also supports Image Shift

I/Q

Selects the front-panel I/Q input ports to be the instrument signal input. If I/Q is

already selected, pressing this key accesses the I/Q setup menu.

The Baseband I/Q functionality is a hardware option. It is option BBA. If the option is

not installed, none of the I/Q functionality is enabled.

The Baseband I/Q has four input ports and one output port. The input ports are I, I-

bar, Q, and Q-bar. The I and I-bar together compose the I channel, and the Q and Q-

2031 Short Range Comms & IoT Mode User's &Programmer's Reference

Keysight x-series Instruction Manual

Other manuals for Keysight x-series