7 Save/Recall/Print
7.1 Quick Save
have been used if you had not entered your own file name.
NOTE
If the filename you entered ends with _dddd, where d=any digit, making it look
just like an auto file name, then the next auto file name picks up where you left off
with the suffix being dddd + 1.
Quick Save Mode
Quick Save can be operated in the Normal mode and in a special “Prompt” mode.
There is a switch on the User Interface page of the System menus that lets you
control this.
When Quick Save Mode is in Normal (the default setting), the instrument does an
immediate save of a new file of the same type and to the same directory as the
previous Save action. When Quick Save Mode is in the Prompt state, instead of
immediately performing a Save, the Alpha Keyboard pops up with the proposed
auto-filename in the entry area. The user can then press Enter to accept the auto
filename, or edit the name and press Enter. This allows you to easily save a file with a
custom file name.
Notes No remote command for this key specifically
2224 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
