LINK OAM Commands
page 26-34 OmniSwitch 6250 CLI Reference Guide November 2009
show efm-oam port statistics
Displays the LINK OAM statistics on a port, or a range of ports or on all ports.
show efm-oam port slot/port[-port2] statistics
show efm-oam port statistics
Syntax Definitions
slot/port Specifies the slot number for the module and the physical port number
on that module (e.g. 3/1 specifies port 1 on slot 3).
-port2 The last port number in a range of ports that you want to configure on
the same slot (e.g. 3/1-4 specifies ports 1,2,3, and 4 on slot 3).
Defaults
By default, the statistics of all ports are displayed.
Platforms Supported
OmniSwitch 6250.
Usage Guidelines
Use the port parameter to display the statistics of a specific port.
Examples
-> show efm-oam port 1/1 statistics
Port 1/1:
Information OAMPDU Tx : 1035,
Information OAMPDU Rx : 988,
Unique Event Notification OAMPDU Tx : 0,
Unique Event Notification OAMPDU Rx : 0,
Duplicate Event Notification OAMPDU TX : 0,
Duplicate Event Notification OAMPDU Rx : 0,
Loopback Control OAMPDU Tx : 1,
Loopback Control OAMPDU Rx : 0,
Unsupported OAMPDU Tx : 0,
Unsupported OAMPDU Rx : 0,
Frames Lost due to OAM : 0
-> show efm-oam port 1/1-4 statistics
Port 1/1:
Information OAMPDU Tx : 1035,
Information OAMPDU Rx : 988,
Unique Event Notification OAMPDU Tx : 0,
Unique Event Notification OAMPDU Rx : 0,
Duplicate Event Notification OAMPDU TX : 0,
Duplicate Event Notification OAMPDU Rx : 0,
Loopback Control OAMPDU Tx : 1,
Loopback Control OAMPDU Rx : 0,
Unsupported OAMPDU Tx : 0,
To Next Page
Loading...
